FORBIDDEN MOTORCYCLES MOTO STYLE BARS STYLE:THROTTLE BY WIRE (TBW / FBW) Fine-tune the angle and sweep

Fine-tune the angle and sweep of your bars to fit your body and riding position

the Harley-Davidson FXRD and FXRT fairings are both considered the same (with upper speaker pods)

Each Precision Lifter is hand assembled to exacting tolerances and designed for quiet operation and rapid pump up and all are made in the USA

Exhaust bracket may require modification when using these kits

The weak and brittle plastic will crack and fail to cause fuel leaks just from the heat of the engine

FORBIDDEN MOTORCYCLES MOTO STYLE BARS STYLE:THROTTLE BY WIRE (TBW / FBW) Fine-tune the angle and sweepFM MOTO STYLE BARS WITH 1" ENDS These moto style bars are designed by Forbidden Motorcycles and made by Fly Racing! They feature the moto typical 1 1 8" clamp area, then taper down to 1" to accommodate stock Harley Davidson hand controls. This then eliminates the need to sleeve them! Pre Drilled for internal wiring! Includes holes to run wires through FM risers however you can drill a hole in the center if needed! Bars have a 32" width, with a 3"