PM46 Perforating wheel 13TPI Numbering and Perforating this is to keep the

this is to keep the surface protected in transit

Care needs to be taken with cleaning the cylinder and positioning the foil as once stuck it cannot be removed without damaging the foil

Plate clamp tensioning nut for GTO52 and 46 which is tool hardened and incorporates a hex for the spanner

New seals and bearings are fitted and then the units are pressure tested before being put into stock

Not suitable for DI machine

PM46 Perforating wheel 13TPI Numbering and Perforating this is to keep theTooth pattern of 13 teeth per inch is normally considered a good choice for thicker card. It fits on to the standard PM QM46 holder