Envirotex Lite stonecarvingsets 2 Clamps to secure into

2 Clamps to secure into 2-Foot or 4-Foot mode

Leaves a zinc phosphate base coating

Super strong - Grade 5

each step is clearly explained and organized to take the carver to a satisfying result

Post curing the mold an additional 4 hours at 150°F (65°C) will eliminate any residual moisture and alcohol that is a by-product of the condensation reaction that can inhibit the cure of some resins and rubbers

Envirotex Lite stonecarvingsets 2 Clamps to secure intoEnviroTex Lite is a water clear 1: 1 mix ration by volume epoxy resin used to coat surfaces. It cures to a long lasting, high gloss coating in approximately 8 hours at 70F, and reaches full strength and toughness in about 72 hours. This durable, resilient material requires no polishing to produce a high gloss. One coat is all that is usually required for an attractive finish, however, two or more coats maybe applied one over the other to build